Top image: The Corgeut Retro Pilot Silver ($165), a hand-wound mechanical watch. Official product photo.
Pick up a mechanical watch and it will be one of two kinds. An automatic watch winds itself from the motion of your wrist. A hand-wound (or manual) watch asks you to turn the crown, usually once a day. Inside, they are close relatives: the same spring, the same gears and the same ticking balance wheel. The difference is simply how energy gets into the spring.
That small difference changes how a watch fits into your day. Here is how each type works, how to wind one, where quartz fits in, and how to choose.
The short answer
- Automatic (self-winding): a weighted rotor spins as you move and winds the mainspring for you. Most automatics can also be wound with the crown.
- Hand-wound (manual): no rotor. You wind the mainspring by turning the crown, typically once a day.
- Quartz (for contrast): not mechanical at all. A battery powers a quartz crystal that keeps time electronically.
Neither mechanical type needs a battery. And "automatic vs. mechanical" is a common mix-up: an automatic is a mechanical watch.
How a mechanical watch works (both types)
Every mechanical watch runs on the same basic chain:
- The mainspring is a long, coiled ribbon of metal inside a drum called the barrel. Winding coils it tighter and stores energy.
- The gear train carries that energy from the barrel toward the hands.
- The escapement and balance wheel release the energy in tiny, even steps. The balance swings back and forth several times a second, and each swing lets the gears advance a fixed amount. That steady rhythm is what keeps time.
- The hands turn as the gears advance.
When the mainspring runs down, the watch stops. The time a fully wound watch keeps running is its power reserve. For mainstream movements this is typically somewhere between about a day and a half and two days, though some run much longer.

What is a hand-wound watch?
A hand-wound watch is the traditional mechanical design. There is no rotor and no battery: turning the crown winds the mainspring directly.
Why people love them
- The ritual. Many owners enjoy the few seconds each morning spent winding the crown.
- An open view of the movement. With no rotor covering the back, a display caseback shows the bridges, wheels and balance clearly.
- Often slimmer. Without a rotor stacked on top, hand-wound movements can be thinner.
The trade-off
Forget to wind it and it stops, so you reset the time before wearing it again.
A Corgeut example: the Retro Pilot
The Corgeut Retro Pilot line is our hand-wound collection. Each model is listed with a Seagull ST3600 hand-wound mechanical movement, a 44 mm case, a big pilot-style dial and a leather strap. As the listing puts it, the movement "has no battery and no self-winding rotor," so you wind the crown regularly, typically once a day.
Sea-Gull's own published specifications for the ST3600 list manual winding, 17 jewels, 21,600 vibrations per hour, a reserve of 46 hours, and a small seconds hand at 9 o'clock (Sea-Gull ST3600 specifications). In practice, a full wind each morning comfortably covers the day.

There are four colorways, all $165 and in stock at the time of writing: Black, Silver, Black with Gold Dials and Silver Bezel and Yellow Dials. The listings do not state a water-resistance rating, so treat the Retro Pilot as a watch to keep dry.

What is an automatic (self-winding) watch?
An automatic watch adds one part to the hand-wound design: a rotor, a half-moon-shaped weight that pivots freely on the back of the movement. Every time your wrist moves, the rotor swings, and a set of reduction gears turns that motion into winding.
Because an automatic would otherwise keep winding all day, its mainspring is fitted with a slipping clutch (often called a slipping bridle). Once the spring is full, it slips instead of winding further, so you cannot overwind an automatic by wearing it.
Why people love them
- Convenience. Wear it most days and it largely looks after itself.
- Everyday versatility. Most sports, dive and bracelet watches are automatics.
The trade-off
Automatics are usually a little thicker because of the rotor, and the rotor covers part of the movement. They also stop if left off the wrist longer than their power reserve.

Corgeut automatic examples
Corgeut Square Automatic Steel Black Dial ($199.99). Listed with a Japanese Miyota 8215 automatic movement, a 44 mm square stainless steel case, a sapphire crystal, an exhibition caseback, an integrated steel bracelet and 5 Bar water resistance. Miyota's specifications for the 8215 list automatic and hand winding, 21 jewels, 21,600 vibrations per hour and a running time of approximately 42 hours (Miyota 8215). See all colorways in the Square Automatics collection.

Corgeut Voyager Automatic Black ($175). Listed with a Japanese NH35 automatic movement, a 40 mm stainless steel case 11 mm thick, a sapphire crystal, luminous marks and hands, a steel bracelet and 5 Bar water resistance. Time Module's technical guide for the NH35A lists automatic and manual winding, hacking seconds, 21,600 vibrations per hour and more than 41 hours of running time when fully wound (TMI NH35A technical guide). More colorways are in the Voyager collection.

Corgeut Mariner Automatic Diver Silver ($175). Listed with a Miyota automatic movement (the listing does not name a specific caliber), a 40 mm stainless steel case, a sapphire crystal, luminous hands, a solid caseback and 100 m water resistance. If you swim, it is the automatic in this guide with the highest listed rating. See the Mariner collection.

Automatic vs. hand-wound vs. quartz at a glance
| Hand-wound | Automatic | Quartz | |
|---|---|---|---|
| Power source | Mainspring, wound by the crown | Mainspring, wound by a rotor (and usually the crown) | Battery |
| Daily effort | Wind it, typically once a day | Wear it; wind it if it has stopped | None until the battery runs out |
| Thickness | Often slimmer | Often a little thicker | Varies, often slim |
| Movement view | Unobstructed | Partly covered by the rotor | Usually not shown |
| Accuracy | Mechanical tolerance | Mechanical tolerance | Typically far more accurate |
| Corgeut example | Retro Pilot | Square Automatic, Voyager, Mariner | Chrono Racer |
Where quartz fits in
A quartz watch is a different technology altogether. A battery sends current through a tiny quartz crystal, which vibrates at a very stable frequency, and a circuit turns those vibrations into regular pulses that drive the hands. There is no mainspring to wind. Quartz is typically far more accurate than any mechanical watch and needs nothing from you until the battery needs replacing.
For comparison, Miyota and Time Module list a tolerance of −20 to +40 seconds per day for the 8215 and NH35, which is normal for a mechanical watch.
Corgeut's one quartz model is the Corgeut Chrono Racer ($130), a Japanese quartz chronograph, not an automatic or a hand-wound watch. It is listed with a 40 mm brushed 316L stainless steel case, a mineral crystal, pushers at 2 and 4 o'clock and 3 ATM water resistance.

How to wind a mechanical watch
Always check the instructions that come with your watch first. The general method is the same for most watches:
- Take it off your wrist. This avoids bending the crown and stem at an awkward angle.
- Unscrew the crown if it is a screw-down crown. Turn it counterclockwise until it pops out to the winding position. A push-pull crown is already in the winding position when pushed in.
- Turn the crown clockwise (away from you, when the watch faces up and the crown is at 3 o'clock) with smooth, even turns.
- Hand-wound watch: keep going until you feel firm resistance, then stop. That means the mainspring is fully wound. Don't force it past that point.
- Automatic watch: if it has stopped, a series of turns (often 20 to 40) is enough to get it running before you put it on; daily wear does the rest. Because of the slipping clutch, you won't feel a hard stop.
- Set the time, then push the crown back in and screw it down if needed.
Tip: wind a hand-wound watch at about the same time each day, and avoid changing the date late at night on watches with a date.
Which one should you choose?
Choose hand-wound if you enjoy a daily ritual, love seeing a movement at work, and are drawn to classic, vintage-style designs. The Retro Pilot is our hand-wound line.
Choose automatic if you want a mechanical watch that mostly takes care of itself when you wear it often. Start with the Square Automatic for the office, the Voyager for everyday wear or the Mariner if you swim.
Choose quartz if you want maximum accuracy and zero upkeep, such as the Chrono Racer.
Still deciding? Our guide on how to choose your first automatic watch covers sizing, crystals and water resistance.
Frequently asked questions
What is the difference between an automatic and a hand-wound watch?
Both are mechanical watches powered by a mainspring. An automatic has a rotor that winds the spring as you move, and most can also be wound by the crown. A hand-wound watch has no rotor, so you wind it yourself, typically once a day.
Is an automatic watch better than a manual watch?
Neither is better; they suit different people. Automatics are more convenient if you wear one watch most days. Hand-wound watches appeal to people who enjoy winding, want a clear view of the movement, or like a slimmer, more traditional watch.
Can you overwind a watch?
You can't overwind an automatic: a slipping clutch lets the mainspring slip once it is full. On a hand-wound watch, stop turning when you feel firm resistance. Forcing the crown past that point can damage the movement.
How long does a hand-wound watch run on a full wind?
It depends on the movement. Sea-Gull lists a 46-hour reserve for the ST3600 used in the Corgeut Retro Pilot. Winding it once a day, at roughly the same time, keeps it running reliably.
Do automatic watches need batteries?
No. Automatic and hand-wound watches are purely mechanical and run on a mainspring. Only quartz watches, like the Corgeut Chrono Racer, use a battery.
What happens if I don't wear my automatic watch?
It runs until its power reserve is used up, then stops. Miyota lists approximately 42 hours for the 8215 and Time Module lists more than 41 hours for the NH35. To restart it, give the crown a series of turns, then reset the time and date.
Find the movement that fits your day
Whether you'd rather wind your watch each morning or let your wrist do the work, there's a Corgeut for it. Explore the hand-wound Retro Pilot collection, or browse automatics in the Square Automatics, Voyager and Mariner collections.
Every order ships free worldwide with duties paid, with processing about 2 days, then shipping about 7 days (times vary by country). If it isn't right, you have 30 days to return it unworn in its original packaging, with no restocking fee; start a return by emailing info@corgeutwatchco.com. New to Corgeut? Use code WELCOME10 for 10% off your first order (one use).
Automatic watches. Elevated style. Honest prices.
Miyota is a trademark of Citizen Watch Co., Ltd.; NH35 is a caliber of Seiko Instruments Inc. / Time Module Inc.; Sea-Gull is a trademark of its respective owner. These names are used only to identify the movements listed on Corgeut product pages. Corgeut is an independent brand and is not affiliated with, endorsed by or sponsored by any of these companies or any other watch company.
Sources: Sea-Gull ST3600 specifications; Miyota 8215 specifications; TMI NH35A technical guide. Corgeut specifications, prices and availability from corgeutwatchco.com product pages, checked 16 November 2026 (America/Chicago).
Image credits: Mainspring close-up by Hustvedt, via Wikimedia Commons, CC BY-SA 3.0. All Corgeut photos are official product images.